SPA Modeler

Hi there,

Using Revell "Plasto" Putty now for many years, I figured out its time for something new. Why? Well, that Revell putty isnt that bad, but there are some better products. It takes ages until it dries and although I stirred it thouroughly, it happened that it stays soft sometimes.

So I tried out MrHobby Putty for the Seafire and was really surprised: It dries fast enough, the shape is really smooth and works perfect.

Whats your experiences? Whats your favourite putty and why?


Regards,


Lucas.

Aside from Magic Sculp, a 2K epoxy putty that rescibes beautiful, I use Tamiya´s Basic Type putty. I have the impression it doesn´t shrink this much, if at all, when drying.

Yes, thats a good point. Revell does, and MrHobby doesnt. Looks like toothpaste.

I've been using Tamiya putty almost exclusively. You can clean it up with nail polish remover.

Medicman71 wrote:I've been using Tamiya putty almost exclusively. You can clean it up with nail polish remover.

Ah! Good to know!

If you plan to do some scribing, I would suggest the use of CA glue + baby powder. It dries fast and the baby powder makes the glue less hard, just like if you used micro-balloons.

LaserEquippedShark wrote:
Tamiyas whit putty is really nice...until it shrinks by 50%.

No such problem with MrHobby White Putty

I use 3M Acryl Red putty. Hate that it's red, but it goes on well, feathers fantastically, and doesn't much, though it will "sink" into depressions sometimes if I thin it too much. I've had the same single tube for 3.5 years, and I've used maybe 10% of it max.