Page 4 of 19
Re: Revell 1/32 F-4G Review & Build
Posted: Fri Aug 12, 2016 7:31 pm
by LyleW
thanks, pal! This should be close to epic.
Re: Revell 1/32 F-4G Review & Build
Posted: Fri Aug 12, 2016 7:58 pm
by Stikpusher
LyleW wrote:thanks, pal! This should be close to epic.
Well now that my self diagnosed modelers OCD is kicking in on this project... I don't know about epic, but I hope you enjoy the show...
Re: Revell 1/32 F-4G Review & Build
Posted: Sat Aug 13, 2016 2:31 am
by Stuart
Good to see this one taking off again.
Re: Revell 1/32 F-4G Review & Build
Posted: Sat Aug 13, 2016 6:56 am
by dogfish7
Re: Revell 1/32 F-4G Review & Build
Posted: Sat Aug 13, 2016 7:50 am
by Paul
I would wait a few days for the acrylics to cure before I put anything else on them, Carlos. The IPs look smashing.
Re: Revell 1/32 F-4G Review & Build
Posted: Sat Aug 13, 2016 3:28 pm
by Stikpusher
Paul, the IPs and side consoles are pretty nicely detailed. Painting them up to best effect should really make em look sweet. As far as letting the seat colors cure goes, the main colors cured long ago.
I should have some decent progress to show in a few days.
Re: Revell 1/32 F-4G Review & Build
Posted: Mon Aug 15, 2016 12:37 am
by Thomas_M
The box shows one of my favourite colour schemes on a F-4. I just re-read this WIP and cannot wait for more!
Re: Revell 1/32 F-4G Review & Build
Posted: Mon Aug 15, 2016 11:02 pm
by Stikpusher
I've been working on detail painting of the ejection seats tonite. I should be able to get some photos up tomorrow.
Re: Revell 1/32 F-4G Review & Build
Posted: Tue Aug 16, 2016 7:32 am
by jelliott523
Really looking forward to seeing the finished product. I have this one sitting in my stash taunting me every now and then. I'm trying to decide if I'm going to go OOB or step up and do some AM stuff for the engine intakes and the seats.
Re: Revell 1/32 F-4G Review & Build
Posted: Tue Aug 16, 2016 10:58 am
by Stikpusher
jelliott523 wrote:Really looking forward to seeing the finished product. I have this one sitting in my stash taunting me every now and then. I'm trying to decide if I'm going to go OOB or step up and do some AM stuff for the engine intakes and the seats.
I highly recommend AM seats already. Or a good bit of modification to the kit parts for the seats. The IPs and side consoles look pretty good compared to photos of the real things, but the seats are needing some work.
